Welch Allyn 2380 - Manual (Page 9)

selections variables
OUTPUT PARAMETERS
USE THIS PAGE
& FORMAT SELECTION
To select the pre–programmed asterisked (*) values by scanning DEFAULT symbol.
To control scanning indicators or enable function records feature.
scan
scan
scan scan scan
Notes:
(1) * Designates DEFAULT selections.
I PREAMBLE (3)
II
III FUNCTION XMIT Enable *Yes/No
(up to 5 chars max)
To add preambles and/or postambles to the bar code.
To select function transmit enable.
POSTAMBLE (4)
To select keyboard type.
(up to 5 chars max)
IV KEYBOARD TYPE 01*
Code ID
Other ASCII
A
B 00–7F
ASCII values A 00–7F
scan
ENTER
DEFAULT
EXIT
V INTERCHARACTER *00–99
DELAY
(2) See facing page for more information and examples.
To set intercharacter, interfunction, and intermessage delays to specific values.
To enable the Append Buffer when Code 3 of 9 with append option is enabled.
VI INTERFUNCTION x5msecs *00–99
DELAY
VII INTERMESSAGE *00–99
DELAY
IX APPEND BUFFER *Yes/No
None*
None*
Primary
Secondary 02
03 Tertiary
Quaternary 04
VIII BEEPER (5, 6) Beep on Reset *Yes/No A
x5msecs
x5msecs
(3) To delete preambles Scan I then either another selection (roman numeral) or Exit.
(4) To delete postambles Scan II then either another selection (roman numeral) or Exit.
SCANTEAM 2380 Programming Menu
Beep on Good Read (7) *Yes/No B
(7) This programming feature is not supported in all models/software revisions.
9
X FUNCTION RECORDS (8) *Yes/No
(5) Default is NO if Beep PC is enabled.
(8) Available for Mask C only.
(6) This programming feature has been changed for Mask C. Refer to the cable
labeling to determine which firmware you have.