Welch Allyn 2380 - Manual (Page 3)

STATUS
CHECK
SCANTEAM 2380/PM Programming Menu
3
Scan the bar code below to display the revision level of the SCANTEAM 2380 firmware.
SHOW FIRMWARE REVISION LEVEL
Scan the bar code below to display the SCANTEAM 2380 software number. The resulting
information will show if there is a special or custom download program resident in the
scanner.
SHOW SOFTWARE NUMBER
Firmware Revision Level
Software Number
The drawing below shows the serial number label that is attached to the scanner cord. The
top number shows the SCANTEAM 2380 model number. This may also be a special 6 digit
part number (custom orders). The serial number is on the second line. The “C” after the serial
number indicates that the firmware Mask revision is C.
SCANNER LABELING
2380/B–211DX
J01 1234C
For example: After scanning the Firmware Revision Level bar code, “(C) WA93C” is output
to the terminal/host device. The “C” at the end indicates the firmware is at revision level C.
For example: After scanning the Software Number bar code, “33961001” is output to the
terminal/host device. That number is the software number.