Wolf ICBWWD30 - Manual (Page 12)

12
W O L F W A R M I N G D R A W E R
IMPORTANT NOTE: Additional clearance
between warming drawer and oven openings
may be required. Check that oven supports do
not obstruct the interior dimensions required
for the warming drawer.
When the warming drawer is installed below
a built-in oven, a minimum of 38 mm between
warming drawer and oven openings is
required for placement of the anti-tip block and
oven platform. When installed above a built-in
oven, a minimum of 22 mm is required.
IMPORTANT NOTE: In an overlay application,
the amount of space between warming drawer
and built-in oven openings may need to be
increased depending on the size of the overlay
panel and the amount of overlap.
I N T E G R AT E D D R A W E R F R O N T
I N S T A L L A T I O N W I T H B U I L T- I N O V E N
The Wolf warming drawer with integrated
drawer front may be installed below or above
a Wolf 762 mm or 914 mm built-in single oven,
provided the warming drawer is fully enclosed,
top and bottom. Refer to the illustration below.
Also refer to installation instructions provided
with the built-in oven for additional specifica-
tions. Dimensions will vary according to the
specific installation.
The Wolf warming drawer is designed and
agency approved for installation with Wolf
built-in ovens.
The warming drawer platform must be able to
support 91 kg. It must be a minimum of 25 mm
above the toe kick to allow for the overlap of
the warming drawer trim.
Installation with Built-In Oven – Integrated Drawer Front