Wolf ICBWWD30 - Manual (Page 6)

6
W O L F W A R M I N G D R A W E R
D R A W E R F R O N T O P T I O N S
IMPORTANT NOTE: Model ICBWWD30 must
be installed with a Wolf stainless steel or
integrated drawer front.
Classic Stainless Steel WWDFRONT/S
Integrated Drawer Front WWDFRONT/I
(accepts wood panel)
Drawer fronts are ordered and shipped as
sales accessories and include additional
installation instructions. Stainless steel drawer
fronts include a matching tubular handle.
The integrated drawer front accepts a custom
wood panel and handle to be provided by the
homeowner. Optional stainless steel tubular
handles in classic stainless steel are available
as sales accessories.
T O O L S A N D M AT E R I A L S R E Q U I R E D
Wood screws or other hardware to install
the solid platform or runners that support
the warming drawer
51 mm x 51 mm or 51 mm x 102 mm
lumber for runners—runners must be able
to support 91 kg
51 mm x 51 mm or 51 mm x 102 mm
lumber for anti-tip block
Power saw
Level
Drill and 1,6 mm bit, 13 mm bit also for
integrated drawer front application
Phillips screwdriver
2 wood screws (provided)
Wood cleats for integrated drawer front
application
A C C E S S O R I E S
Optional
accessories are
available through
your Wolf dealer.
B E F O R E Y O U S T A R T
Before you install the warming drawer,
make sure you have the Wolf accessory
drawer front called for in your installation.
IMPORTANT NOTE: If you are installing
the warming drawer with integrated drawer
front in an inset panel application, make
sure that your cabinetry meets the
minimum 838 mm width and 635 mm depth
requirement for this installation.
Check with local utilities for electrical codes
that apply in your area. Local codes vary.
Installation, electrical connections and
grounding must comply with applicable
codes.
This appliance must be properly grounded.
Refer to Electrical Requirements on
page 14.
Make sure you have the tools and materials
necessary for proper installation.