Walker 5600-20 - Manual (Page 15)

ASSEMBLY
OM 0352SB-A
12
16. Figure 5: Place the hand guard (item 2)
inside the chute (item 1) and align the
holes. Fasten with four 1/4"NC x 1/2" hex
bolts (item 3) and four 1/4"NC serrated
flange nuts (item 4). Tighten firmly.
17. Figure 6: Place the chute (item 1) on the
chute base (item 8).
18. Figure 6: Align the holes of the three
retaining plates (item 8) with the holes in
the chute base.
19. Figure 6: Attach the rear and right hand
side retaining plates with one 1/4"NC x 1/2"
hex. bolt (item 4) in the hole shown on the
figure and the front retaining plate with two
1/4"NC x 1/2" hex. bolts (item 4) and
secure with four 1/4"NC serrated flange
nuts (item 9).
20. Figure 6: Insert the two 1/4"NC x 1 3/4"
hex. bolts (item 7) in the rotation stoppers
(item 6),the spacer rings (item 5) and in the
remaining holes of the rear and right hand
side retaining plates (item 3) and secure in
place with two 1/4"NC serrated flange nuts
(item 9). Tighten the nuts firmly.
21. Figure 7: Insert the grommet (item 1) in
the hole of the rotation support (item 2).
22. Figure 7: Insert the second grommet (item
3) in the hole of the handle support (item 4)
and slide it over the rotation handle (item
5) until the grommet rests against the flat
washer welded on the rotation handle.
23. Figure 7: Fasten the handle support (item
4) to the welded handle support (item 2)
with two 1/4"NC x 1/2" hex. bolts (item 6)
and two 1/4"NC serrated flange bolts (item
7). Tighten firmly.
24. Figure 7: Install the 1/2" plastic handle
(item 8) on the rotation handle (item 5).
Figure 5
Figure 6
Figure 7