Walker 5600-20 - Manual (Page 16)

ASSEMBLY
OM 0352SB-A
13
Snowblower Installation on the Tractor
1. Remove the mower deck from the tractor if
necessary. Refer to the appropriate Tractor
Owner’s Manuel.
2. Figure 8: Attach each lift chain (item 5) to
the lift bracket (item 1) with a 5/16" NC x
1 1/4" bolt (item 6) and a 5/16" NC nylon
insert locknut (item 7).
3. Figure 8: Attach each lift bracket (item 1)
to the predrilled holes (item 2) on the front
chassis cross bar with a 5/16"NC x 1" bolt
(item 3) and a 5/16"NC serrated flange nut
(item 4).
NOTE: Predrilled holes exist only on Walker
tractors built after 1984. For earlier models, drill
two 5/16" (8mm) holes in the front chassis
cross bar at the positions indicated.
IMPORTANT: For all 1980 to 1984 tractors,
remove the battery before drilling the right hand
hole. Reinstall the battery after the lift brackets
have been installed. Refer to the appropriate
Tractor Owner’s Manual for battery removal
and installation procedures.
4. Figure 9: Place the male half driveline
(item 1) of the snowblower PTO shaft into
the socket of the female PTO with quick
coupler (item 2) and rotate the PTO shaft
until it is aligned correctly with the socket in
the female PTO with quick coupler, then
slide together.
Figure 8
Figure 9