Whynter FX-7SB/W - Manual (Page 5)

5
LOADING THE DISPENSER
PROPER INSTALLATION AND LOCATION
LOCATION

The water dispenser should be installed in an
environment where the temperature ranges
between 10ºC/ 50ºF and 33ºC / 90ºF. Relative
humidity should not be higher than 90%

Avoid direct sunshine
TIPS

If the dispenser is not going to be used for an
extended period of time, turn the switches at the
back to the OFF position, unplug the power cord
and drain the remaining water

The rear of the water dispenser should be at
least 10 inches / 25 centimeters from the wall to
allow for proper air circulation

Never place the water dispenser on carpet, foam
or any other unstable surface

Do not place flammable items near the water
dispenser

In case the hot or cold water is not needed for an
extended period of time, turn off the appropriate
power switch at the back of the dispenser to save
electricity
WARNING: The dispenser should not be turned on
until at least 3 minutes after it was turned off.
PRIOR TO FIRST TIME USE
IMPORTANT: Prior to using the Water Dispenser for the first time, the water tanks need to be flushed in
order to prevent the water from tasting awkward.
The water dispenser tanks also need to be cleaned periodically to prevent buildup of mineral deposits that can affect
water taste and flow. To clean the water tanks:
1. Make sure that the power switches are in the OFF
position
2. Create a solution of one quart of water with either
one quart of vinegar or four ounces of lemon juice.
Make enough so you can fill the water tank all the
way to the top.
3. Remove the bottle supporter and pour the solution
in the opening at the top of the dispenser.
4. Let the cleaning solution sit inside the unit for
about 1 hour, drain out the cleaning solution from
the drain plug at the back of the unit. When no
more water comes from drain plug, press the hot
and cold dispenser buttons to drain out the
solution.
5. Rinse the water dispenser with clean water.
6. Install the water bottle ( see Loading the
Dispenser, page 5)
IMPORTANT: Before use, dispense at least one quart of water from each tap to make sure the cleaning solution
is completely removed.
IMPORTANT: Make sure the dispenser is unplugged
with both the hot (red) and cold (green)power
switches set to the OFF position. Before loading, wipe
the top of the bottle with a clean cloth and wash
hands. Avoid touching the part of the bottle that will
be directly in contact with the water dispenser.
1. Invert a 3 or 5 gallon water bottle on top of the
cooler and place securely on the bottle support
collar
2. Press the hot and cold dispenser buttons until
water runs from both taps
3. Plug in the water dispenser. Do NOT turn on both
hot and cold switches at the same time.
4. Turn on the hot (red) power switch at the back, the
Hot red heating LED indicator turns on and the
heating system starts working. When the hot water
reaches a temperature of approx. 95ºC / 203ºF,
the red light turns off and the heating system
stops. The machine turns to keeping warm mode.
When the hot water temperature drops below 80ºC
/ 176ºF, the heating system will automatically
resumes.
5. Turn on the cold (green) power switch, the green