Whynter FX-7SB/W - Manual (Page 7)

7
5 After about one hour, press the hot & cold
buttons until no more water comes out of the
taps.
IMPORTANT: Before use, dispense at least one
quart of water from each tap to make sure the
cleaning solution is completely removed.
Draining the Dispenser
IMPORTANT: Put both power switches to the OFF
position and UNPLUG the water dispenser before
draining. Allow the dispenser to cool overnight before
draining to reduce the risk of scalding
The dispenser should be drained before cleaning the
tanks or if it will not be used for extended periods.
1. Remove the water bottle from the dispenser.
2. Place a bucket beneath the drain plug. The drain
plug is located at the rear of the dispenser (see
image below).
7. Remove the cap from the drain plug and allow
water to drain completely. Replace the cap.
8. Press both dispenser buttons until no more water
comes out of the taps.