Whynter FX-7SB/W - Manual (Page 8)

8
TROUBLESHOOTING TIPS
Please check the following troubleshooting tips before calling the customer service line or having the machine
repaired.
Problem
Possible Causes What To Do
Water not hot enough or
cold enough Dispenser is unplugged Push the power plug completely into the outlet
and make sure that the applicable switches are
set to the ON position
The circuit breaker has been tripped Reset the circuit breaker
All the water in the water tank has
been used Wait 1 hour for the dispenser to heat or cool a
new batch of water
Water dispenser does not
work Empty water bottle Replace with new bottle of water
Mineral deposits are clogging the
tanks See Cleaning and Caring for the Dispenser
(page 7)
No water coming out of the
cold water faucet Ice has formed in the cold water
supply pipe Turn off the green cooling power switch at the
back of the unit for around 4 hours to let the ice
melt
Water bottle is warm or hot Crack or pin hole in bottle
Low water level in the bottle Replace with a new bottle of water
Replace with a new bottle of water
Water dispenser leaks
from the outside Crack or pin hole in bottle Replace with a new bottle of water
Water dispenser is noisy Water Dispenser is on an uneven
surface Make sure the water dispenser is installed on a
flat and level floor which is strong enough to
support it when fully loaded
Bottle making a gurgling noise as
water fills the tanks This is normal