Williams Sound TEL 040 - Manual (Page 11)

11
TELETALKER ™ Model TEL 040 Installation Guide & User Manual
Answering A Call
Step 1: Check the Volume Control setting, lift the handset.
Step 2: Press the Amplify button. The red Amplify indicator
should light.
Step 3: Adjust the Volume and Tone controls to comfortable set-
tings.
Step 4: When you hang-up the phone, the Amplify function
automatically turns off.
Using the TELETALKER With A Hearing Aid
The handset can be used directly with hearing aids equipped with a
telecoil (T-coil ). Move your hearing aid T-switch to the “T” posi-
tion and hold the handset close to your hearing aid. The volume
can be adjusted with the TELETALKER volume control.
Using the TELETALKER With Auxiliary Assistive Listening Devices
Through its 3.5mm Neckloop/Aux Jack, the TELETALKER can
be used with a variety of assistive listening devices (ALDs) such
as neckloops, headphones, and cochlear processors. Note:
An attenuator cord (WCA 040) must be used with cochlear
processors. Neckloops may be plugged directly into the jack.
Step 1: Plug the device into the Neckloop/Aux jack (see fig. 8).
Step 2: Set the volume control to about half of full.
Step 3: Turn on the ALD and adjust the volume for comfortable
listening.
Step 4: If the sound is weak, increase the volume on the
TELETALKER, then on your ALD.
fig. 8: Connecting An ALD