Williams Sound TEL 040 - Manual (Page 6)

Installation Guide & User Manual TELETALKER ™ Model TEL 040
6
Installation Steps
Step 1: Make sure you have a 115 VAC wall outlet and tele-
phone jack within 6 feet of the place you’ve chosen to
install the telephone. If you have an older 4-prong jack,
you’ll need a modular jack adapter. These adapters are
available from electronic, phone, and other retail stores.
Step 2: Place the Pulse/Tone Switch, located on the side of the
phone, in either Tone or Pulse (Rotary Dial Pulse).
Make sure you choose the correct dialing mode. Tone
dialing will not work if you have only dial pulse (rotary)
service.
Step 3: Set Ringer Volume and Tone Controls to desired level.
(see fig.3)
Step 4: Plug the coiled handset cord into the handset. Plug the
other end into the telephone base. (see fig. 4)
RINGER
OFF LO HI RINGER T ONE I II III
Ringer Tone Control
Adjusts ringer pitch (I, II, III)
Ringer Volume Control
Adjusts ringer volume (Hi, Lo, Off)
fig. 3: Ringer Controls
fig. 4: Handset Connection
PULSE TONE AC 12 V/0.85A TO TEL. LINE
Pulse / Tone Switch
Switches between touch-tone
and rotary dial modes.
fig. 2: Pulse/Tone Switch