Williams Sound TEL 040 - Manual (Page 12)

Installation Guide & User Manual TELETALKER ™ Model TEL 040
12
In Case Of Difficulty
Cannot hear the other person speak. This only occurs
when the TELETALKER is in Amplify mode.
When you use the Amplify feature, the TELETALKER operates
in half-duplex mode. This means that while you speak, the hand-
set receiver shuts off. If it did not, the extremely loud volumes
produced by the TELETALKER would cause feedback.
When using the TELETALKER in Amplify mode, do not speak
when the other party is speaking.
Can answer calls but cannot make them
The pulse/tone switch is set in the wrong position. Change it to
pulse mode.
No dial tone when you pick-up handset
There are a number of potential causes to this problem:
1. Cords on handset or phone are not plugged into jacks. Make
sure connectors are plugged in securely.
2. The cord could be damaged. If so, replace the cord.
3. The wall jack could be improperly wired. Check the wall jack
for proper wiring.
4. Your phone line could be out of order. Contact your local
phone company.
Can make calls, but phone doesn’t ring for incoming calls.
There are a number of potential causes to this problem:
1. The handset may not be placed properly on the base. Make
sure it is resting properly on the base.