Hyundai H-CMMD4042 - Manual (Page 48)

48
TFT auto open: set the monitor working mode when the unit is on and off: On (when the unit is off the
monitor draws down into the unit automatically, when it’s on the monitor unfurls automatically), Off (when the
unit is off the monitor draws down into the unit automatically, when it’s on the monitor unfurls by pressing the
OPEN/CLOSE button on the panel), Manual (when the unit is off or on the monitor draws down or unfurls only
by pressing the OPEN/CLOSE button on the panel).
Audio sound processing configuration
1. Enter the ASP CONFIG menu.
2. Use the
buttons on the panel or / buttons on the RC or touch
the desired item on the screen to select the desired setting: Bass center
freq, Treble center freq, SUB filter, SUB phase, Bass Q-factor.
3. Press the buttons on the panel or / buttons on the RC touch
the desired button on the screen to enter the list of values.
4. Press the buttons on the panel or / buttons on the RC touch
the desired button on the screen to select the desired value.
5. Press PLAY/PAUSE / ENTER / SCAN button to confirm.
Bass center frequency: select the Bass center frequency according to the audio source disc: 60 Hz, 80 Hz, 100
Hz, 130 Hz, 150 Hz, 200 Hz.
Treble center frequency: select the Treble center frequency according to the audio source disc: 10 KHz, 12.5
KHz, 15 KHz, 17 KHz.
Sub filter: set a cut-off frequency of the subwoofer’s LPF (low pass filter) and that of the “Small” speakers’
HPF (high pass filter). Crossover frequency setting has no effect if the subwoofer is set OFF and any other
speaker set is “Large”.
Select a crossover frequency: 80 Hz, 120 Hz, 160 Hz.