Windmere I-210 - Manual (Page 6)

10 9
How to Use
This appliance is for household use only.
GETTING STARTED
remove any labels, stickers or tags attached to the body or soleplate of the iron.
Note: Use ordinary tap water for ironing. Do not use water processed through a
water softening system.
Important: For optimum performance, let the iron stand for 90 seconds before
beginning to iron.
TO FILL THE WATER TANK
1. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the MAX level mark on the
water tank (A). do not overfill. refill as needed.
2. Plug in the iron. Temperature-ready light glows when iron has
reached set temperature setting.
Tip: if unsure of a garment’s fabric, test a small area (on an inside
seam or hem) before ironing.
FOR STEAM IRONING
1. Move the dry/steam selector to the desired steam level (B).
2. Turn the fabric-select dial to appropriate setting (between
4 and 6) for your fabric (C). See fabric guide on the heel
rest and read garment’s label to help you determine fabric
type. The temperature-ready light glows until it reaches the
appropriate temperature. it then cycles on and off during
ironing.
3. When finished ironing, turn the fabric-select dial to lowest heat
setting, move the selector to
J
K
L
M
O
and unplug the iron. Stand the
iron on its heel rest and allow it to cool off.
Important: Always stand the iron on its heel rest when powered on but not in
use.
FOR DRY IRONING
1. Make sure dry/steam selector is set to
J
K
L
M
O
(D).
Note: It is recommended that you empty the water
(see “Emptying Water Tank After Ironing”).
g
A
B
a b
C
D
2. Turn the fabric-select dial to the appropriate setting for your
fabric (E). See fabric guide on the heel rest and read garment’s
label to help you determine fabric type. The temperature-ready
light glows until it reaches the appropriate temperature. it then
cycles on and off during ironing.
Note: For optimum performance, let the iron stand for
90 seconds before beginning to iron.
3. When finished ironing, turn the fabric-select dial to lowest heat setting, move
the selector to
J
K
L
M
O
and unplug the iron. Stand the iron on its heel rest and allow
it to cool off.
Important: Always stand the iron on its heel rest when powered on but
not in use.
EMPTYING WATER TANK AFTER IRONING
Note: It is not necessary to empty the water after each use.
1. Turn the fabric-select dial to
J
K
L
M
O
. unplug the iron.
Stand the iron on its heel rest and allow it to cool off.
2. Empty the water by holding the iron over a sink with the tip
pointing down. Water will empty out of water-fill opening (F).
Care and Cleaning
This product contains no user serviceable parts. refer service to qualified service
personnel.
CLEANING OUTSIDE SURFACES
1. Make sure iron is unplugged and has cooled completely. Wipe the soleplate
and outer surfaces with a soft cloth dampened with water. never use abrasives,
heavy-duty cleansers, vinegar or scouring pads that may scratch or discolor
the iron.
2. After cleaning, steam iron over an old cloth to remove any residue from the
steam vents.
STORING YOUR IRON
1. check that the selector is set to
J
K
L
M
O
.
2. unplug the iron. Stand the iron on its heel rest and allow it to cool off.
3. Store vertically on its heel rest to prevent water leaking from the soleplate,
or you can empty the water tank.
E
F