White Outdoor Z - 180 - Manual (Page 19)

19
ADJUSTING BRAKE FORCE
Figure 13
1. Place the Z-series on level surface without the brake engaged and place blocks behind the wheels.
2. Turn the engine OFF and remove the key from the ignition.
3. From underneath the Z-series directly behind the caster wheel pivot bar, locate the brake rods. There are two,
one on the right and one on the left. (See Figure 13)
4. The factory sets a 1/16” gap minimum between the brake arm and frame of the Z-Series.
More adjustment may be necessary. (See Figure 13)
NOTE: If after adjusting the brake, the proper force has not been obtained more adjustment may be required.
5. Repeat process on the other brake rod.
6. Check the operation of the brakes before operating. If the adjustment does not help, see your dealer.
If: Then:
Increased force is needed Rotate brake rods clockwise.
Decreased force is needed Rotate brake rods counterclockwise.
Brake Rod
Frame
Brake Arm
Measure Gap