Windows Marketplace V.90 - Manual (Page 34)

34
Result Codes:
OK n = 0, 1
ERROR Otherwise
Wn Result Code Option
W0: CONNECT result code reports DTE speed. Disable protocol result codes.
W1: CONNECT result code reports DTE speed. Enable protocol result codes.
W2: CONNECT result code reports DCE speed. Enable protocol result codes
(default).
Result Codes:
OK n = 0, 1, 2
ERROR Otherwise
Xn Result Code Selection and Call Progress Monitoring
This command enables tone detection options used in the dialing process. As these
functions are chosen, the modem chipset’s result codes are also affected. There-
fore, this command is frequently used to control the modem chipset’s responses.
The primary function of this control is to control the modem chip set’s call re-
sponse capabilities.
Extended Result Codes
Disabled: Displays only the basic result codes OK, CONNECT, RING,
NO CARRIER, and ERROR.
Enabled: Displays basic result codes, along with the connect message
and the modem’s data rate, and an indication of the modem’s
error correction and data compression operation.
Dial Tone Detect
Disabled: The modem dials a call regardless of whether it detects a dial
tone. The period of time the modem waits before dialing is speci-
fied in register S6.
Enabled: The modem dials only upon detection of a dial tone, and dis-
connects the call if the dial tone is not detected within 10 sec-
onds.