Windows Marketplace V.90 - Manual (Page 52)

52
Range: 0 − 255
Default: 43
Units: ASCII
S3 Command Line Termination Character (user defined)
This register determines the ASCII values as the carriage return character. This
character is used to end command lines and result codes.
Range: 0 − 127, ASCII decimal
Default: 13 (carriage return)
Units: ASCII
S4 Response Formatting Character (user defined)
This register determines the ASCII value used as the line feed character. The
modem uses a line feed character in command mode when it responds to the com-
puter.
Range: 0 − 127, ASCII decimal
Default: 10 (line feed)
Units: ASCII
S5 Command Line Editing Character (user defined)
This register sets the character recognized as a backspace and pertains to
asynchronous only. The modem will not recognize the backspace character if it
is set to a value that is greater than 32 ASCII. This character can be used to edit
a command line. When the echo command is enabled, the modem echoes back
to the local DTE the backspace character, an ASCII space character, and a
second backspace character. This means a total of three characters are transmit-
ted each time the modem processes the backspace character.
Range: 0 − 32, 127
Default: 8 (backspace)
Units: ASCII
S6 Wait Before Dialing
This register sets the length of time, in seconds, that the modem must wait (pause)
after going off-hook before dialing the first digit of the telephone number. The
modem always pauses for a minimum of two seconds, even if the value of S6 is
less than two seconds. The wait for dial tone call progress feature (W dial modi-
fier in the dial string) will override the value in register S6. This operation, how-