Western Telematic MPC-20VS16-3 - Manual (Page 188)

17-9
Command Reference Guide
/D Third Party Disconnect
Invoke the /D command at your resident port to disconnect two other ports.
Notes:
• The /D command cannot disconnect your resident port
• Users are limited to the ports that are specifically allowed by their accounts.
Availability: Administrator, SuperUser, User
Format:
/D[/Y] <x> [x] [Enter]
Where:
/Y (Optional) suppresses the "Sure?" prompt.
x Is the number or name of the port(s) to be disconnected. To disconnect
all allowed ports, enter an asterisk. To disconnect a Telnet session, enter
the " Nn" format Network Port Number.
Response: "Are you Sure (y/n)?", if Y, unit will respond with "Disconnected".
Example: To disconnect Port 2 from Port 3 without the "Sure?" prompt, access the
Command Mode from a third port with Administrator level command capability and type:
/D/Y 2 [Enter] or /D/Y 3 [Enter]
/U Send Parameters to File
Sends all MPC configuration parameters to an ASCII text file as described in Section 13.
This allows you to back up the configuration of your MPC unit.
Availability: Administrator
Format:
/U [Enter]
/K Send SSH Key
Instructs the MPC to provide you with a public SSH key for validation purposes. This
public key can then be provided to your SSH client, in order to prevent the SSH client
from warning you that the user is not recognized when you attempt to create an SSH
connection. For more information, please refer to Section 10.
Availability: Administrator
Format:
/K k [Enter]
Where k is a required argument, which indicates the key type. The k argument
provides the following options: 1 (SSH1), 2 (SSH2 RSA), 3 (SSH2 DSA.)