Western Telematic MPC-20VS16-3 User Manual
Page 89
5-58
Basic Configuration
• SNMPv3 User Name: Sets the User Name for SNMPv3. Note that this option is
not available when the Version parameter is set to V1/V2. (Default = undefined.)
• SNMPv3 Password: Sets the password for SNMPv3. Note that this option is not
available when the Version parameter is set to V1/V2. (Default = undefined.)
• SNMPv3 Password Confirm: This prompt is used to confirm the SNMPv3
password that was entered at the prompt above. Note that this option is not
available when the Version parameter is set to V1/V2. (Default = undefined.)
• Authentication Protocol: This parameter determines which authentication protocol
will be used. The MPC supports both MD5 and SHA1 authentication.
(Default = MD5.)
Notes:
• The Authentication Protocol that is selected for the MPC must match the
protocol that your SNMP client will use when querying the MPC unit.
• The Authentication Protocol option is not available when the Version
parameter is set to V1/V2
• SNMP Contact: (Default = undefined.)
• SNMP Location: (Default = undefined.)
• SNMP Community: Note that this parameter is not available when the SNMP
Version is set to V3. (Default = Public.)