Whirlpool T-K2 - Manual (Page 3)

For Your Safety
PLEASE READ THIS MANUAL CAREFULLY
AND FOLLOW IT EXACTLY FOR YOUR
SAFETY.
1. Follow all local codes, or in the absence of
local codes, follow the most recent edition
of the National Fuel Gas Code, ANSI
Z223.1/NFPA 54 in USA or the CGA
standard, CAN/CGA B149.1 or .2
Installation Codes for Gas Burning
Appliances in Canada.
2. Properly ground the unit in accordance
with all local codes, or in the absence of
local codes, with the National Electrical
Codes, ANSI/NFPA 70 in the USA or CSA
standard C22.1 Canada Electrical Code
Part 1 in Canada.
3. Carefully plan where to install your Flash
Water Heater. Insure that your heater will
have enough combustible air, proper
ventilation, and locate your heater where
water leakage will not do damage to
surrounding areas. If there is a possibility
of water damage, install a suitable drain
pan under the unit, which will not restrict
combustible airflow.
4. Check the rating plate for the correct gas
type, gas pressure, water pressure, and
electrical rating. Do not install this unit if
these requirements can’t be met.
5. If a problem should occur, turn off all hot
water taps and turn off the gas. Call a
trained technician, the Gas Company, or
the manufacturer.
6. WARNING: Do not disconnect the
electrical supply if the temperatures will be
near freezing. The Freeze Prevention
Device will only work if the unit has proper
electrical power. The Freeze Prevention
Device is rated for temperatures down to
5º F (-15º C) in a wind free environment.
The wind chill factor will cause the Flash
Water Heater to freeze and be damaged at
temperatures above 5º F (-15º C). Refer to
the sections on Winterizing and the Freeze
Prevention Device for more information.
7. WARNING: Before bathing or showering
always check the water temperature. Do
not leave children or the infirm
unsupervised in the shower or bath. The
water temperature is set at 120º F (50º C)
from the factory to maximize the amount of
hot water you can use. Water temperature
over 125º F can cause severe burns
instantly or death from scalds.
8. WARNING: Do not use this appliance if
any part has been underwater.
Immediately call a certified and trained
technician to inspect and service the unit if
necessary.
9. WARNING: Do not store or use gasoline or
other flammable vapors or liquids in the
vicinity of this or any other appliance.
10. WARNING: Do not reverse the water and
gas connections, this will damage your
heater and can cause severe injury or
death from scalds. Follow the diagram
below when installing your Flash water
heater.
Rating plate