Weider 148 - Manual (Page 7)

7
3. Attach an ÒLÓ Bracket (42) and the Right Upright (1)
to the right side of the Rear Base (27) with two M10
x 75mm Bolts (46), three M10 Washers (53) and
one M10 Nylon Locknut (54). Make sure the
Uprights are oriented as shown, so the welded
tube extends beyond the edge of the Upright on
the indicated side. Note: The lower hole in the
Rear Base is threaded, so this Bolt does not
require a Nylon Locknut.
Attach the Left Upright (16) and the remaining ÒLÓ
Bracket (42) to the left side of the Rear Base (27) in
the same manner.
4. Attach the Front Leg (8) to the Frame (2) with three
M8 x 16mm Screws (51) and three M8 Washers
(20). Note: Make sure you tighten the Screws
very hard.
5. Attach the Frame (2) to the Crossbar (3) with two
M10 x 60mm Bolts (47), four M10 Washers (53), a
Support Plate (14) and two M10 Nylon Locknuts
(54).
Attach the Front Leg (8) to the Front Base (29) with
two M8 x 50mm Carriage Bolts (45), two M8
Washers (20) and two M8 Nylon Locknuts (39).
6. Attach a Dip Handle (24) to one of the Weight
Rests (19) with an M8 x 60mm Bolt (43), an 11mm
x 10.5mm Spacer (44), two M8 Washers (20) and
an M8 Nylon Locknut (39). Slide a Handgrip (12)
onto the Dip Handle. Press a 25.4mm Round Inner
Cap (59) into the end of the Dip Handle.
Attach the other Dip Handle (24) to the other
Weight Rest (19) in the same manner.
Attach the Right Barbell Hook (28) to the Weight
Rest (19) with an M8 Washer (20) and an M8 Nylon
Locknut (39). The Barbell Hook must be oriented
as shown.
Attach the Left Barbell Hook (30) to the other
Weight Rest (19) in the same manner.
6
3
4
5
46
53
53
1
53
54
27
54
53
42
53
53
46
16
42
51 8
51
8
20
20
2
2
39
20
45
20
29
47
53
54
3
14
47
53
19
30
28
44
24
20
39
43
20
59
19
12
39
20
Welded
Tube
Extends
Welded
Tube
Extends