Zebra Technologies Printers - Manual (Page 39)

Removing A
Partially Used
Transfer Ribbon
A partially used transfer ribbon can be removed
by following the steps below.
The unused portion of partially used transfer
ribbons can be reloaded using the normal rib-
bon loading procedure.
Step ➊ Open the print carriage to release ribbon ten-
sion. Using scissors, cut the transfer ribbon just
below the take-up roll.
Step ➋ Remove the supply roll and tape the end to
prevent it from unwrapping.
Step ➌ Remove the take-up roll.
Discard used ribbon off the take-up core. Save
the empty take-up core for when you load
ribbon again.
980181-001 Rev.C
31
Operation