Zebra Technologies Printers - Manual (Page 45)

Cleaning Under
the Sensor Bracket
The transmissive (gap) sensor guide bar bracket
can pivot up for easy cleaning.
Step 1 Open the print head carriage.
Step 2 Open the sensor bracket. Pull the slide lock to
the left and lift the front of the bracket up.
Step 3 Clean the metal part of the bracket, only. The
sensor is recessed to protect it from labels and
adhesive.
Clean the clear sensor window below the sensor
bracket. Do not use abrasive cleaning materials.
Only use water on a lint free, clean, damp cloth
very lightly moistened. Let dry. Verify that the
window is clear of streaks and clouding.
Step 4 Swing the sensor bracket down to close. The
slide lock will automatically lock when in posi-
tion.
Close the print carriage.
980181-001 Rev.C
37
Operation
Transmissive (Gap)
Sensor Bracket
Slide Lock