ZyXEL Communications ZyXEL Dimension ES-3124 - Manual (Page 185)

Dimension ES-3124 Ethernet Switch
Routing Protocol 24-1
Chapter 24
Routing Protocol
This chapter shows you how to configure the routing functions.
24.1 Static Route
Static routes tell the ES-3124 how to forward IP traffic when you configure the TCP/IP parameters manually.
Click Routing Protocol in the navigation panel and then Static Routing to display the screen as shown.
Figure 24-1 Static Routing
The following table describes the related labels you use to create a static route.
Table 24-1 Static Routing
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name for this route. This is for identification purpose only.
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.