Yamaha RX-V365 - Manual (Page 44)

40
En
This unit has additional menus that are displayed on the front panel display. The advanced setup menu offers additional
operations to adjust and customize the way this unit operates. Change the initial settings (indicated by (*) in this
following parameter) to reflect the needs of your listening environment.
Notes
• Only ASTANDBY/ON, LPROGRAM l / h and
MSTRAIGHT are effective while you are using the advanced setup
menu.
• No other operations can be made while you are using the advanced setup
menu.
• The advanced setup menu is only available on the front panel display.
1
Press ASTANDBY/ON on the front panel to
set this unit to the standby mode.
2
Press and hold KTONE CONTROL and
then press ASTANDBY/ON to turn on this
unit.
This unit turns on, and the advanced setup menu
appears on the front panel display.
3
Press LPROGRAM l / h to select the
parameter you want to adjust.
The name of the selected parameter appears on the
front panel display.
4
Press MSTRAIGHT repeatedly to change
the selected parameter setting.
5
Press ASTANDBY/ON to confirm your
selection and set this unit to the standby
mode.
y
• The settings you made are reflected next time you turn on this unit.
■ Speaker impedance SP IMP.
(U.S.A. and Canada models only)
Use this feature to set the speaker impedance of this unit
so that it matches that of your speakers.
Choices: 8
ΩMIN*, 6ΩMIN
• Select “8
ΩMIN” to set the speaker impedance to 8 Ω .
• Select “6
ΩMIN” to set the speaker impedance to 6 Ω .
■ Initializing PRESET
Use this feature to reset all the parameters of this unit to
the initial factory settings.
Choices: CANCEL*, RESET
• Select “CANCEL” not to reset any parameters of this
unit.
• Select “RESET” to reset the parameters of this unit.
Notes
• This setting completely resets all the parameters of this unit including the
set menu parameters. However, the advanced setup menu parameters will
not be initialized.
• The initial factory settings are activated next time you turn on this unit.
Advanced setup
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6
ΩMIN” as follows BEFORE using this unit.
SP IMP. Speaker Impedance level
8
ΩMIN
Front (A or B) The impedance of each
speaker must be 8
Ω or
higher.
Center
Surround
6
ΩMIN
Front (A or B) The impedance of each
speaker must be 6
Ω or
higher.
Center
Surround