Zanussi ZC 605 M - Manual (Page 16)

70
Normal power Reduced power NATURAL GAS LPG
Mark
1/100
G20
20
mbar
G25
25
mbar
g/h Mark
1/100
G 30 G 31
m 3 /h
kW kW
Semi-rapid
Auxiliary 1
2
Natural gas:
3
LPG : 2,8
0,33
0,45
0,65
70
96
119
0,095
0,190
0,286
0,111
0,221
0,332
50
71
86
72,5
145
203
71,5
143
200
Rapid
BURNER
Fig. 14
Fig. 15
Fig. 16
FO 2127
FO 0392
HOB BURNERS
NOZZLES REPLACEMENT
- Remove the pan supports.
- Extract the caps and the wall baffles of the burners.
- Using a socket spanner 7 unscrew and remove (fig.
16) the nozzles replacing them with the ones required
for the kind of gas in use (see table).
Reassemble the parts following the same procedure
backwards.
These burners do not need any primary air regulation.
HOB BURNERS
ADJUSTMENT OF MINIMUM LEVEL
To adjust the minimum level:
1) turn the knob to the position of minimum flame;
2) remove the knob (Fig. 17);
3a) in case of conversion from natural gas to LPG,
tightly screw the by-pass screw of the cocks;
3b) when converting from LPG to natural gas unscrew
about one-fourth turn by-pass screw, until a
regular small flame is reached.
Reassemble the parts following the same procedure
backards.
Check that, turning quickly the knob from the maximum
position to the minimum one, the flame does not go out.
ADAPTATION TO DIFFERENT
KINDS OF GAS
To adapt the appliance to a different kind of gas from
the one the appliance has been set for, follow the
instructions below in their order.
GAS CONNECTION (Fig. 15)
LPG : use the rubber pipe holder «C».
Natural gas : use the pipe fitting «A».
Always insert the gasket «B» (Fig. 15). Then proceed
with the gas connection, as indicated in the relevant
paragraphs.