Zanussi ZDC37100W - Manual (Page 11)

11
Start/Pause Button
Press this button to
start the dryer after
having selected the
programme and the
options. The rele-
vant light will stop
flashing. If the pro-
gramme selector dial is turned to
another position, when the machine is
running, the buzzer will sound and the
programme phase indicator lights will
flash. The drum turns alternately in
both directions during drying.
All drying programmes end with a 10
minute cooling phase . You may
remove the laundry after this phase.
If the door of the appliance or the small
door at the bottom is opened while the
programme is running, this button must
be pressed again after closing the door
in order to restart the programme from
the point at which it was interrupted.
This button must be depressed also
after a power failure and after having
reinserted the water reservoir, if it has
been emptied in the middle of a pro-
gramme after lighting up of light
“Empty Tank”.
In both cases the light of the
“Start/Pause” button flashes to remind
you that the start button needs to be
pressed again.
4. Indicator lights
These lights indicate the following
functions:
• Drying light - this light indicates that
the appliance is in the drying phase.
• Cooling light - this light indicates that
the appliance is in the cooling
phase.
• End / Anticrease light - this light is on
at the end of the cooling phase, dur-
ing the anti-creasing phase and at
the end of the programme.
• Empty Tank light - this light indicates
that the appliance is in the drying
phase. This light comes on at the
end of the programme to remind you
that the water reservoir must be
emptied out. If this light illuminates
during a programme this means that
the water reservoir is full. The
buzzer sounds, the programme
stops, the light of the Start/Pause
button flashes. This light comes on
also when the water reservoir is not
inserted correctly.
• Filter - this light illuminates at the end
of the programme to remind you that
the filters must be cleaned.
• Condenser- It comes on every 80
cycles to remind you that the con-
denser must be cleaned.
Cancelling a programme
Turn the selector dial to “Off” to cancel
a programme which is running. You
can now select a new programme.
At the end of the programme
If the laundry is not removed at the end
of the cycle, the dryer performs an
anticreasing phase (duration: 30 min-
utes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of the anti-creasing phase. Lights
“End/Anticrease”, and “Empty Tank”
remain lit and the buzzer sounds for 2
minutes.
Turn the programme selector dial to
“Off” to switch the machine off.
Remove the laundry from the drum and