Zanussi ZDC37100W - Manual (Page 14)

14
Important!
Do not use the appliance without fil-
ters.
Cleaning the condenser unit
Clean the condenser when light
“Condenser” comes on.
The condenser is situated at the lower
part of the cabinet behind a small door.
To open the door, push the catch as
per picture.
During the drying cycle or at the end, it is
normal for water to be present on the sur-
face of the condenser insertion.
To pull out the condenser, first turn the
two red stops downwards and then
remove the condenser unit holding it at
the handle.
„
Clean it with a brush and rinse it under
the shower if necessary. Also clean the
outside, removing all fluff. Clean the rub-
ber seal round the condenser cabinet
and in the inner part of the small door
with a damp cloth.
Important
Do not use pointed objects or utensils to
clean the spaces between the plates, as
this could damage the condenser and
make it permeable. Re-fit the condenser,
turn the red stops upwards and close the
door.
Important!
Do not use this appliance if the con-
denser has not been fitted.
Emptying the water reservoir
Water extracted from the laundry
condenses inside the machine and is
collected in a reservoir. The reservoir
must be emptied after each drying cycle
to ensure efficient operation when the
machine is next used. The pilot light
Empty tank reminds you of this