Zanussi ZDC37100W - Manual (Page 17)

17
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase
date of your machine: the Service
Centre will require this information.
1206
If you call out an engineer to a fault
listed below, or to repair a fault caused
by incorrect use or installation, a
charge will be made even if the
appliance is under guarantee.
Malfunction Possible cause Solution
When pressing a
button, the
corresponding button
flashes several times. • Washing protection.
After the start of the
programme, the option
can no longer be set.
• Turn the programme
knob to “0” Set the pro-
gramme again
Drying cycle ends
shortly after
programme starts.
END light
illuminated.
• Not enough washing
loaded or washing
loaded is too dry for
selected programme.
• Select time programme
Programme inactive,
Water reservoir full
light illuminated.
• Water reservoir is full.
• Empty the water reser-
voir, then start pro-
gramme with
START/PAUSE button.
Drying cycle lasts an
unusually long time.
Note: After around 5
hours the drying cycle
ends automatically
(see „Drying cycle
complete“)
• Lint filter clogged.
• Heat exchanger
clogged with lint.
• DELICATE button
pressed and load vol-
ume too big.
• Load volume too big.
• Laundry insufficiently
predrained.
• Clean lint filter
• Clean heat exchanger.
• DELICATE is only suit-
able for use with loads of
up to 3 kg!
• Reduce load volume.
• Laundry must be ade-
quately pre-drained.
Important
: