Yamaha DG60FX-112 - Manual (Page 21)

21
External Control Settings
• trE : Tone Control (TREBLE)
• nnd : Tone Control (MIDDLE)
• bAS : Tone Control (BASS)
• PrE : Tone Control (PRESENCE)
• CP : Compressor Effect’s COMP setting
• SPd : Modulation Effect’s SPEED setting
• dPt : Modulation Effect’s DEPTH setting
• SP2 : The secondary parameter of the
Modulation Effect’s SPEED knob
• dP2 : The secondary parameter of the
Modulation Effect’s DEPTH knob
• ti : Delay Effect’s TIME setting
• Fb : Delay Effect’s FEEDBACK setting
• LE : Delay Effect’s LEVEL setting
• rE : Reverb Effect’s LEVEL setting
• OFF : Off (no control)
These parameters (setting values) can be con-
trolled using the controller that is set in step 3.
5. Press the [PHASER] button.
Sets the controller’s minimum parameter value.
Use the [UP]/[DOWN] buttons to set the value
(0.0-10.0)
6. Press the [ROTARY] button,
Sets the controller’s maximum parameter value.
Use the [UP]/[DOWN] buttons to set the value
(0.0-10.0).
7. Press the [UTILITY] button to return to the Play
Mode.
Connecting an optional foot controller (expression pedal) such as the YAMAHA FC-7 to the
EXP. PEDAL jack on the Foot Switch Unit lets you control the volume and tone of the DG60FX-
112 and effect parameters (value settings). It is also possible to control these parameters with
MIDI control changes.
■ Procedure
1. In the Play Mode, simultaneously press the
[MANUAL] button and the [UTILITY] button.
Enter the external control setting mode and
“ CtL ” will appear on the display.
2. Press the [COMP] button.
A control number will appear on the display.
Use the [UP]/[DOWN] buttons to set the control
number.
Up to 8 programmed control settings can be as-
signed to control numbers 1-8 in the DG60FX-
112. A separate controller can be used to control
each programmed control setting or a single con-
troller can be used to control all control settings
separately.
3. Press the [CHORUS] button.
The controller type will appear in the display.
Use the [UP]/[DOWN] buttons to set the type of
controller.
• EP : Control is by the foot controller con-
nected to the EXP. PEDAL jack.
• 1 - 3 1 , 6 4 - 9 5 : Control is by control
change data received from an ex-
ternal MIDI device connected to the
MIDI IN jack. Select the control
change number. (Refer to the
Owner’s Manual for the external
MIDI device for information in MIDI
control change numbers.)
4. Press the [FLANGER] button.
The type of parameter will appear in the display.
Use the [UP]/[DOWN] buttons to select the pa-
rameter to be controlled.
• UUH : Use as a wah pedal.
• b.Pr : Volume (pre preamp.)
• A.Pr : Volume (post preamp.)
• A.rE : Volume (post reverb)
These external control settings are included
in the patch data.
Also, in the Utility settings, there is a func-
tion not related to patch settings that sets
the External Controller’s Operating Mode. The
External Controller can be set to operate
Globaly, by Program (patch) or always OFF.
(
→
page 25)