Yamaha D5000 - Manual (Page 10)

8 - Program Select Mode
D5000
Press the [ > ] "
RECALL " CURSOR key.
If you have not made any changes to the previous settings, it will be replaced with the new
program.
If you made a mistake selecting the new program or you decide you do not want to replace the
current program, you can cancel the RECALL operation by pressing any key except the
[ > ]
" RECALL " CURSOR key.
Storing a program
Storing a program overwrites the data that was previously stored under that program number. If
you decide that you do not want to replace the program or that you made a mistake selecting the
program number, you can cancel the STORE operation by pressing any key other than the
[ < ]
" STORE " CURSOR key.
If you have made changes to the previous settings without storing them,
the unit will additionally display the message "
Are you sure? " on the
LCD. Press the [ > ] "
RECALL " CURSOR key again to complete your
selection. The previous program will be replaced with the new program.
Press the [ PROGRAM ] key to enter Program Select Mode. The LED on the
key will light and the LCD will display the title of the current program.
Press the [ < ] "
STORE " CURSOR key. The message " [STORE] " will be
displayed on the LCD along with a message showing the " From: " and
" To: " program numbers.
NOTE If the SOFTWARE PROTECT parameter of Utility Mode is not set to OFF, the LCD will temporarily
display the message "
Protected ! " when you attempt to store a program.
Rotate the DATA ENTRY encoder or press the
[ ^ ] and [ % ] CURSOR keys
to select the program number that you want for use to storing your
settings.
Press the [ < ] "
STORE " CURSOR key again to confirm that this is what you
want to do. The message " Complete ! " will briefly appear on the LCD.