ZyXEL Communications P-660W-Tx v2 User Manual
Page 6
P-660W-Tx v2 Quick Start Guide
5
2.2.2 Configure Internet Access and Local Network Settings with the
Connection Wizard
Use the Connection Wizard to set up access to the Internet through your ISP. These are
your WAN (wide area network) settings. Then use the Connection Wizard to set up the
connection from your computer to the P-660W-Tx v2. These are your LAN (local area
network) settings.
"
Enter the Internet access information given to you by your ISP exactly in
each wizard screen. Follow the instructions in this guide or leave the field
blank or at its default setting. Click Next to continue or click Back to return
to the previous screen. Screen information is not saved when you click
Back. If your connection times out, log back in and restart the Wizard.
1 From the Mode drop-down list box, select
Routing if your P-660W-Tx v2 is a gateway
between the Internet and your local network and
you need routing features such as NAT (Network
Address Translation) or a firewall. Select Bridge
if your P-660W-Tx v2 is on a private network
behind a router, and you do not need routing
features such as NAT or a firewall.
2 Configure your Encapsulation, Multiplex and
other settings based on the settings your ISP
provides you.
Bridge
• If you selected Bridge and RFC 1483 in the previous screen, go to step
in this section.
• If you selected Bridge in step
of this sec-
tion and PPPoA, the following screen
appears. Type your User Name and Pass-
word. Select Nailed-Up Connection to set
a permanent connection which automatically
reconnects on disconnection. Select Con-
nect on Demand to allow connection only
when required and with an idle time-out
period (in seconds) in the Max. Idle Timeout
field. Click Next.