Yamaha CRW4001t - Manual (Page 15)

Chapter 2 - Installing the Yamaha CRW4001t Drive
9
7. Connect the AUDIO cable.
Connect the single 4-pin connector (Sound Blaster compatible) to the
sound card. Connect the 4-pin connector at the other end of the cable (the
larger connector) to the AUDIO OUT connector on the CRW4001t drive.
The polarizing lug should be at the top.
R G
L
AUDIO OUT
CSEL
SLAVE
MASTER
SER. NO.
IDE INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
R G
L
AUDIO OUT
CSEL
SLAVE
MASTER
SER. NO.
IDE INTERFACE CONNECTOR
1
DC INPUT
+5V G +12V
To the CRW4001t
4-pin connector (large)
To the CDR100/102
(3-pin connector)
To the Sound Card (Sond Blaster compatible)
4-pin connector (small)
* Simultaneous use with the
CRW4001t is not possible.
AUDIO Cable