Yamaha 9000 Pro - Manual (Page 29)

Registration Memory Registration Memory
29
Registering the Panel Settings
You can also create your own Registration Memory setups.
1
Set up the panel controls as required.
2
Select a Registration Bank (04 through 64).
Avoid selecting one of the Registration Banks 01 through 03 (even though they
can be selected), since you may inadvertently delete some important data.
(See the note below.)
3
Press the [MEMORY] button.
The LCD display will prompt you to select the desired Registration number.
Press the [MEMORY] button again to exit from this display.
4
Press one of the REGISTRATION MEMORY buttons: [1]
through [8].
In this example, the panel settings are memorized to button number 3.
1
1
2
2
3
3
BAN
REGISTRATION MEMORY
FREEZE REGIST BANK 1~64
MEMORY
REGISTRATION
ONE TOUCH SETTING
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
BANK VIEW
REGISTRATION MEMORY
FREEZE REGIST BANK 1~64
Since all Registration Memory data is stored to Flash ROM, any data in the Registration Memory location you selected
in step #2 above will be erased and replaced by your new settings. This includes the factory programmed preset Reg-
istration Memory settings (banks 01 - 03). If you've deleted the factory-set data, you can use the Restore function
(page 154) to load a copy of it from the included disks (page 6).
For details about Flash ROM, refer to “Memory Structure” on page 54.
1 2 3 4 5 6 7 8
BANK 01
04~64
These banks do not
contain preset setups.
Registration Memory banks
64 banks in Flash ROM
All banks can be edited.
01~03
These banks contain preset
setups (factory settings).
27