Yamaha MC802 - Manual (Page 17)

n n INPUT CHARACTERISTICS
INPUT
PAD
INPUT
INPUT LEVELS
SOURCE MAXIMUM
GAIN
SENSITIVITY**
CONNECTOR
IMPEDANCE IMPEDANCE RATED LEVEL NON CLlPPING TYPE
LEVEL
–60dB 50 ~ 600 ohms –80dB (0.08mV) –60dB (0.8mV) –34dB (15.5mV)
XLR-3-31 type
( Balanced)
CH INPUT
OFF(0dB) LO-Z 4k ohms Microphones
–20dB
HI-Z 10k ohms
–40dB (7.75mV)
or
ON(20dB) 600 ohms Lines
–20dB (77.5mV) +6dB (1.65V) and
–20dB (77.5mV) –0dB (775mV) +26dB (15.5V)
Phone Jack (TRS)
(Balanced)
INPUT CH INSERT lN 10k ohms 600 ohms Lines –26dB (38.8mV) –6dB (388mV) +20dB (7.75V)
Phone Jack (TRS)
(Unbalanced)
ST SUB IN, AUX SUB IN 10k ohms 600 ohms Lines –6dB (388mV) +4dB (1.23V) +20dB (7.75V)
Phone Jack
(Unbalanced)
AUX RTN 10k ohms 600 ohms Lines –16dB (123mV) +4dB (1.23V) –
Phone Jack
(Unbalanced)
TALKBACK IN 4k ohms
50 ~ 600 ohms
Microphones
–70dB (0.25mV) –50dB (2.45mV) –24dB (48.9)
XLR-3-31 type
(Unbalanced)
n n OUTPUT CHARACTERISTICS
OUTPUT
OUTPUT
IMPEDANCE
O U T P U T L E V E L S
LOAD IMPEDANCE
RATED LEVEL
MAXIMUM NON- CONNECTOR TYPE
CLIPPING LEVEL
ST OUT 150 ohms 600 ohms Lines +4dB (1.23V) +24dB (12.3V)
XLR-3-32 type
(Balanced)
AUX SEND 1 3 150 ohms 600 ohms Lines +4dB (1.23V) +20dB (7.75V)
Phone Jack
(Unbalanced)
INPUT CH INSERT OUT 600 ohms 10k ohms Lines –6dB (388mV) +20dB (7.75V)
Phone Jack (TRS)
(Unbalanced)
PHONES 100 ohms
8 ohms Phones
40 ohms Phones
1mW 20mW
Stereo Phone Jack
3mW 130mW (Unbalanced)
** Input level required to produce rated +4dB output level.
• 0dB = 0.775Vr.m.s.
SERVICE
This product is supported by Yamaha’s worldwide network of
factory trained and qualified dealer service personnel. In the event
of a problem, contact your nearest Yamaha dealer.
15