Yamaha MC802 - Manual (Page 8)

Master Control Section
AUX SEND (1, 2 & 3) Controls & CUE Switches
These adjust the overall output level of the auxiliary
"mixes" set up using the AUX 1, AUX 2 and AUX 3 con-
trols on the input channels. AUX SEND 1 sets the overall
level of the AUX 1 mix signal appearing at the AUX
SEND 1 jack, AUX SEND 2 sets the overall level of the
AUX 2 mix signal appearing at the AUX SEND 2 jack,
and AUX SEND 3 sets the overall level of the AUX 3
mix appearing at the AUX SEND 3 jack. These controls
should be used to optimally match the AUX SEND out-
put level of the mixing console to the input sensitivity of
the effect unit, signal processing device or amplifier used.
The CUE switches associated with each AUX SEND con-
trol can be used to send the corresponding AUX SEND
signal to the PHONES jack via the CUE/PHONES level
control. The AUX cue signal will be added to any other
active cue signal. If you want to monitor only the signal
from a single AUX buss, make sure all other CUE switches
are turned OFF.
AUX RTN 1 & AUX RTN 2 Controls
These controls adjust the level of the signal received at the
rear-panel AUX RTN jacks and mixed into the main
stereo program. Since stereo AUX returns are provided
(AUX RTN 1 L & R, AUX RTN 2 L & R) the AUX RE-
TURN controls simultaneously adjust the level of the
signals appearing at the corresponding L and R return
inputs. The returned L and R channel signals are sent to
the L and R stereo buss lines. If only a single-channel
signal is returned (i.e. a plug is inserted into only the L or
R return jack), the signal will be fed to both the L and R
channels of the stereo buss.
6