Zanussi ZBM 799 - Manual (Page 19)

39
Cleaning Materials
Check that the use of cleaning products are
recommended by the manufacturer on
various finishes e.g. vitreous enamel and
stainless steel.
Cleaners that contain bleach or are abrasive
should NOT be used on this appliance.
General Cleaning
Wash enamelled parts after each use. Let the
oven cool and remove fat deposits using a
sponge cloth with soapy water or a mild
detergent.
Rinse stainless steel parts with water and
wipe them with a soft cloth. For hard stains
use specific products for stainless steel or
some arm vinegar. Do not use abrasive clea-
ning products.
Oven Shelves
To clean the oven shelves, soak in warm
soapy water and remove subborn marks with
a well wetted, soap impregnated pad. Rinse
well and dry with a soft cloth.
Cleaning the Oven Door
The internal glass of the oven door can be
removed and cleaned. To do so follow these
instructions:
1. Using a flat bladed screwdriver, loosen
the four screws fixing the glass to the
oven door (Fig. 5).
2. Remove the glass and clean in warm
soapy water.
3. Replace by positioning the glass in the
door and refitting the four screws.
Oven Lamp Replacement
The Bulb can be replaced by following these
instructions (Fig. 6):
1. Isolate the appliance from the mains.
2. Remove the glass protection cap.
3. Remove the bulb and replace it with
another one suitable for higher tempera-
tures (300°C) with the following specifi-
cations:
Voltage
220-240 V / 50 Hz
Power 15 W
Socket E14
4. Reassemble the glass cap and then recon-
nect the appliance to the power supply.
Before carrying out any maintenance or
cleaning disconnect the appliance from
the supply.
For safety reasons cleaning the applian-
ce with a steam jet cleaner or high-pres-
sure water cleaner is NOT permissible!
Cleaning and Maintenance
fig. 6
fig. 5
150 Rev 1del 06 /03 Rex 12-06-2003 15:15 Pagina 39