Zanussi ZBM 799 - Manual (Page 21)

41
Electrical Connections
The oven is designed to be connected to
220-240V (50Hz) electricity supply. The
oven has an easily accessible oven block
which is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
THIS APPLIANCE MUST BE
EARTHED
The cable used to connect the oven to the
electrical supply should have the characteri-
stics indicated in the table.
It is necessary that you install a double pole
switch between the appliance and the electri-
city supply (mains), with a minimum gap of
3 mm between the switch contacts and of a
type suitable for the required load in com-
pliance with the current rules.
The switch must not break the yellow and
green earth cable at any point.
Important
After installation and connecting, the cable
must be placed so that it cannot at any point
reach a temperature of more than 50°C or
above the ambient temperature.
Before the appliance is connected, check
that the main fuse and the domestic installa-
tion can support the load; and that the power
supply is properly earthed.
The manufacturer disclaims any responsabi-
lity should these safety measures not be car-
ried out.
This appliance meets the requirements laid
down in EEC Directive No. 89/336 relating
to the suppression of radio and TV interfe-
rence.
Insertion into Modular Furniture
For built-in appliances it is necessary that
furniture has suitable dimensions;
dimensions of the oven, of the space and
instruction for insertion and assembly follow
(Fig. 8). Compliance with safety regulations
protection against contacts with electrical
parts must be assured by a correct insertion
of the appliance. All safety relevant parts,
even a possible covering panel (if an
appliance is placed at the end or at the
beginning of a row of furniture) must be
fixed in a way that it is impossible to remo-
ve them without using tools. In modular fur-
niture plastic material layers and veneered
would should be treated with glue resistant
to a temperature of 85°C. Plastic materials
or glues not resistant to this temperature can
cause deformations or ungluing.
Please ensure that when the appliance is
installed it is easily accessible for the engi-
neer in the event of a breakdown.
It is mandatory that all operations
for the installation of this cooker be
carried out by qualified and compe-
tent persons to the relevant British
Standards.
Installation Instructions
The manufacturer declines all
responsability if safety regulations
are not strictly observed.
Model Rating Cable Cross Fuse
Section mm2 Min.
and type of cable
ZBM 2,685 1,5
799X Ho5 RR-F 13A
150 Rev 1del 06 /03 Rex 12-06-2003 15:15 Pagina 41