Yamaha RX-V995 - Manual (Page 12)

8
Installing batteries in the remote
controller
Since the remote controller will be used for many of this unit’s
control operations, you should begin by installing the supplied
batteries.
1. Turn the remote controller over and slide the battery
compartment cover in the direction of the arrow.
2. Insert the batteries (AA, LR6, UM-3 type) according to the
polarity markings on the inside of the battery compartment.
3. Close the battery compartment cover.
4.
After the batteries are inserted, press the RESET button
before using the remote controller.
Notes about the remote controller
Battery replacement
If you find that the remote controller must be used closer to the
main unit, the batteries are weak. Replace both batteries with
new ones.
Notes
● Use only AA, R6, UM-3 batteries.
(It is recommended to use an LR6 type to use the remote
controller for a long period of time.)
● Be sure the polarities are correct. (See the illustration inside
the battery compartment.)
● Remove the batteries if the remote controller is not used for
an extended period of time.
● If batteries leak, dispose of them immediately. Avoid
touching the leaked material and contact with clothing, etc.
Clean the battery compartment thoroughly before installing
new batteries.
Remote controller operation range
Notes
● The area between the remote controller and the main unit
must be clear of large obstacles.
● Do not expose the remote control sensor to strong lighting,
in particular, an inverter type fluorescent lamp. Otherwise,
the remote controller may not work properly. If necessary,
position the main unit away from direct lighting.
1
3
2
RESET button
30 ° 30
°
0 20 l00 ROOM 2 CONTROL 40 60 RT PS PTY PTY HOLD EON NEWS INFO AFFAIRS SPORT CT A B
Remote control
sensor
Within approximately
6 m (19.7 feet)
GETTING STARTED