Yamaha RX-V995 - Manual (Page 26)

22
Speakers
SEE INSTRUCTION MANUAL FOR CORRECT SETTING. CAUTION
CENTER REAR IN OUT
OUTPUT
A
B
A
B
REAR
MAIN
SUB
WOOFER
OUTPUT
( SURROUND )
( SURROUND )
REMOTE
CONTROL
MAIN
CENTER
IMPEDANCE SELECTOR
CENTER : 4 Ω MIN. / SPEAKER
REAR : 6 Ω MIN. / SPEAKER
MAIN
A OR B : 4 Ω MIN. / SPEAKER
A B : 8 Ω MIN. / SPEAKER
CENTER : 8 Ω MIN. / SPEAKER
REAR : 8 Ω MIN. / SPEAKER
MAIN
A OR B : 8
Ω MIN. / SPEAKER
A B :I6 Ω MIN. / SPEAKER
SET BEFORE POWER ON
SPEAKERS
Center speaker
Left
(U.S.A. model)
Right
Main speakers A
Rear speakers Subwoofer system
Left Right Left Right
Use speakers with the specified impedance shown on the rear of this unit.
Red: positive (+)
Black: negative (–)
➀ Loosen the knob.
➁
Insert the bare wire.
[Remove approx. 5mm
(1/4”) insulation from
the speaker wires.]
➂
Tighten the knob and
secure the wire.
< Except Singapore model >
Banana Plug connections are also possible. Simply insert the
Banana Plug connector into the corresponding terminal.
1
2
3
How to Connect:
Connect the SPEAKERS terminals to your speakers with the wire of the proper gauge (keep as short as possible). If the
connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct. That is
the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.
Caution
Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the
speakers, or both.
PREPARATION
Main speakers B