Zebra Technologies Z6M - Manual (Page 81)

Zebra Z4M/Z6M Printers User’s Guide 73
&DOLEUDWLRQ
&RPPXQLFDWLRQ 3UREOHPV
$ ODEHO IRUPDW ZDV VHQW WR WKH SULQWHU EXW QRW UHFRJQL]HG 7KH '$7$ OLJKW
GRHV QRW IODVK
Problem Solution
Loss of printing registration on labels.
Excessive vertical drift in top-of-form
registration.
Adjust the reflective sensor position. See page 10.
Set the printer for the correct media type. See page 41.
Ensure that the media guides are properly positioned.
Via the front panel, locate the “SENSOR SELECT” menu
item (page 41) and manually select the correct sensing
method.
Reload the media. Check the reflective sensor position
(see page 10).
Clean the platen roller according to the instructions on
page 56.
“Auto Calibrate” failed.
Perform a manual calibration (see page 45).
Load the media. Ensure that the reflective sensor is
properly positioned (see page 10).
Problem Solution
The printer does not respond to label
requests.
Check the printer driver or software communications
settings (if applicable).
Verify the prefix and delimiter characters. See page 49.
Confirm you are using the correct communication cable.
See “Cabling Requirements” on page 18.
Via the front panel, check the protocol setting. It should be
set to the default “none.” See page 47.
Ensure that the correct driver is being used (if applicable).