ZyXEL Communications NPS-520 - Manual (Page 25)

Chapter 2 ZyXEL Utility
NPS-520 User’s Guide
25
Figure 8 ZyXEL Utility: TCP/IP Setting
The following table describes the labels in this screen.
Table 6 ZyXEL Utility: TCP/IP Setting
LABEL DESCRIPTION
Print Server This is the NPS-520’s descriptive name you configure in the System Setting
screen.
Static IP Select this option if there is not a DHCP server in the network to which the
NPS-520 is connected and configure the TCP/IP information in the fields
below.
IP Address Enter the IP address of the NPS-520. The IP address should be in the same
subnet of the network to which the NPS-520 is connected.
Note: The NPS-520‘s default IP address is 192.168.1.6.
Subnet Mask Enter the subnet mask of the NPS-520.
Gateway Enter the IP address of the default gateway in the network to which the NPS-
520 is connected.
Dynamic IP Select this option to have the DHCP server (in the network to which the NPS-
520 is connected) assign the NPS-520 an IP address automatically.
The fields below are grayed out when you select this option.
Note: We recommend you give the NPS-520 a static IP address
or configure your DHCP server to always give it the same
IP address (static DHCP). If the NPS-520's IP address
changes, you need to uninstall and reinstall the ZyXEL
utility on each computer that uses it.