Zanussi 156985811-00-082009 - Manual (Page 7)

1 2
3
Fill the salt container with
1 litre of water (only the
first operation).
4
5 6
It is normal that water overflows from the salt con-
tainer when you fill it with salt.
Make sure that there is no grain of salt outer of the
salt compartment. Salt which stays on the tank for
a while drills the tank. It is recommended to start a wash-
ing programme immediately after you fill the salt con-
tainer. This prevents of corrosion because of spilled salt.
When you set electronically the water softener to level 1,
the salt indicator light does not stay on.
Use of rinse aid
Caution! Only use branded rinse aid for
dishwashers.
Do these steps to fill the rinse aid dispenser:
1 2
M A X
1 2
3 4
+
3 4
Caution! Do not fill the rinse aid dispenser with
other products (e.g. dishwasher cleaning agent,
liquid detergent). There is a risk of damage to the ap-
pliance.
Adjusting the dosage of rinse aid
M A X
1 2
3 4
+
The rinse aid dial is set at
the factory at position 3.
To increase or decrease
the dosage refer to 'What
to do if...'
7