Yamaha PORTATONE PSR-OR700 - Manual (Page 167)

PSR-OR700 Owner’s Manual 167
Using
Your Instrument with
Other Devices
Using Your Instrument with Other Devices
Connecting Audio Devices
n
Use audio cables and adaptor plugs having no (zero) resistance.
Using External Audio Devices for Play-
back (
1 [OUTPUT] jacks)
You can connect these jacks to a stereo system to
amplify the instrument’s sound. Use audio cables for
connection as shown in the diagrams. These jacks are
located on the underside jacks panel of the instrument.
When these are connected, you can use the instrument’s
[MASTER VOLUME] control to adjust the volume of the
sound output to the external device. Connect the instru-
ment’s OUTPUT [L/L+R]/[R] jacks (standard phone
jacks) and the input jacks of a pair of powered speakers
using appropriate audio cables. Use only the [L/L+R]
jack for connection with a monaural device.
Playing External Audio Devices with the
Built-in Speakers (
2 [AUX IN] jacks)
The stereo outputs from another instrument can be con-
nected to these jacks, allowing the sound of an external
instrument to be reproduced via the instrument’s speak-
ers. Connect the output jacks (LINE OUT etc.) of an
external synthesizer or the tone generator module and
the instrument’s AUX IN [L/L+R]/[R] jacks using appro-
priate audio cables.
n
• Use only the [L/L+R] jack for connection with a monaural device.
• The instrument’s [MASTER VOLUME] setting affects the input
signal from the [AUX IN] jacks.
USB
TO DEVICE TO HOST
MIDI FOOT PEDAL
IN OUT 1 2
1 2
3 4 5 6
P. 172
P. 167
P. 171 P. 168
P. 167
P. 171
CAUTION
Before connecting the instrument to other electronic
components, turn off the power of all the components.
Also, before turning any components on or off, make sure
to set all volume levels to minimum (0). Otherwise, elec-
trical shock or damage to the components may occur.
CAUTION
• When the instrument’s sound is output to an external
device, first turn on the power to the instrument, then
to the external device. Reverse this order when you turn
the power off.
• Do not route the output from the [OUTPUT] jacks to the
[AUX IN] jacks. If you make this connection, the signal
input at the [AUX IN] jacks is output from the [OUTPUT]
jacks. These connections could result in a feedback loop
that will make normal performance impossible, and
may even damage both pieces of equipment.
CAUTION
When the sound of an external device is output to the
instrument, first turn on the power to the external device,
then to the instrument. Reverse this order when you turn
the power off.
Instrument
Powered speakers
Input jack
Phone plug
(standard) Phone plug
(standard)
Audio cable
Instrument
Synthesizer
Tone generator
Phone plug
(standard)
Audio cable
Pin plug
LINE OUT