Yamaha RX-V495RDS - Manual (Page 30)

30
AUTOMATIC TUNING
1
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
or
2
Press TUNING MODE so that the “AUTO TUNING”
indicator lights up on the display.
Front panel
Lights up
3
To tune in to a higher frequency, press the UP side of
TUNING once.
To tune in to a lower frequency, press the DOWN side
of TUNING once.
Front panel
* If the station where the tuning search stops is not the
desired one, press once more.
* If the tuning search does not stop at the desired station
(because the signal from the station is weak), take the
manual tuning procedure.
TUNING OPERATIONS
Set INPUT on the front panel to the TUNER position. When using the remote control transmitter, press AMP<TUNER> on the
component selector and then press TUNER on the input selector.
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).
MANUAL TUNING
1
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
or
2
Press TUNING MODE.
Front panel
3
Tune in manually to the desired station.
Front panel
* To continue the tuning search, press and hold the button.
Notes
• If you tune in manually to an FM station, it will be
automatically received in monaural mode to increase the
signal quality.
• If an RDS station that employs the PS data service is being
received, the station name is shown on the display.
Confirm that the “AUTO
TUNING” indicator goes off.
3 2
1
01RX-V495RDS-3 6/22/99, 12:27 PM 30