Yamaha RX-V495RDS - Manual (Page 40)

40
SETTING THE SLEEP TIMER
The SLEEP timer can be used to make this unit automatically switch to the standby mode. When you are going to sleep while
enjoying a broadcast or other desired program source, this timer function is useful. The SLEEP timer can only be controlled with
the remote control transmitter.
Notes
• To set the SLEEP timer for this unit, press AMP<TUNER>, TAPE/MD, CD or DVD/LD on the component selector.
• The components for which the SLEEP timer is effective are the sources connected to the SWITCHED AC OUTLET(S) on the rear
panel of this unit.
To set the SLEEP time
1
Press SLEEP once or more to select the desired
SLEEP time.
Remote control
The SLEEP time is displayed.
Flashes
Each time you press SLEEP, the SLEEP time will change as
follows:
(Minutes)
120 90 60 30
The SLEEP timer is off (SLEEP OFF).
(This is the state before SLEEP is
pressed.)
The “SLEEP” indicator soon lights up and the display returns
to the indication before the SLEEP timer was set.
2
The unit will be switched to the standby mode
automatically at the selected SLEEP time.
To cancel the selected SLEEP time
Remote control
Press SLEEP once or more so that “SLEEP OFF” appears on
the display. (It will soon disappear and the “SLEEP” indicator
will go off from the display.)
Note
The SLEEP timer setting can also be canceled by setting the
unit in the standby mode with STANDBY/ON on the front panel
(or POWER on the remote control transmitter) or by
disconnecting the power plug of the unit from the AC outlet.
1
01RX-V495RDS-3 6/22/99, 12:28 PM 40