ZyXEL Communications Prestige 2000W - Manual (Page 75)

Prestige 2000W_V2 User’s Guide
Chapter 12 User Web Configurator Screens 75
Figure 14 DHCP Network Configuration
Table 8 DHCP
LABEL DESCRIPTION
Get IP Address
Network Mode Click STATIC to manually enter a fixed IP address.
Click DHCP to have the Prestige automatically obtain network settings at startup
from a Dynamic Host Configuration Protocol server. These settings are not
configurable.
Click PPPoE if your ISP uses Point-to-Point Protocol over Ethernet.
Network IP This is the IP address your Prestige uses to connect to the wireless LAN.
Network Subnet
Mask
The subnet mask specifies the network number portion of an IP address.
Default Gateway This field displays the gateway IP address for your Prestige to connect.
MAC Address Every Ethernet device has a unique MAC (Media Access Control) address. The
MAC address is assigned at the factory and consists of six pairs of hexadecimal
characters, for example, 00:A0:C5:00:00:02.
This field is read only and cannot be configured.
DNS Server IP This field displays the IP address of the DNS server for translating readable domain
names into valid computer IP addresses.
Second DNS
Server IP
This field displays the IP address of the backup DNS server for the Prestige to use in
the event that the Prestige cannot connect to the preferred DNS.
APPLY Click APPLY to save your changes without restarting the Prestige. Your wireless
LAN, Internet and SIP settings changes do not take affect until you use RESTART
(in the navigation panel).
CANCEL Click CANCEL to begin configuring this screen afresh.