Heat sink – Yamaha AG-STOMP GA 011589 User Manual
Page 14
Advertising
AG-Stomp
14
Fig.4
4.
Heat Sink (Manhour requirement: 25 min.)
4-1.
Remove the bottom case. (See Procedure 1.)
4-2.
Remove the DM circuit board. (See Procedure 2.)
4-3.
Remove the two (2) screws marked [A-a] from the
soldered face of the DM circuit board and the three
(3) screws marked [A-b] from IC112, IC113 and
IC114. The heat sink can then be removed from the
DM circuit board. (Fig. 4)
[A-a]
[A-a]
[A-b]
IC114
IC113
IC112
Heat Sink
Advertising