Zanussi ZCE 700 - Manual (Page 18)

18
Oven Cavity
The enamelled oven cavity is best cleaned whilst the
oven is still warm.
Wipe the oven over with a soft cloth soaked in warm
soapy water after each use. From time to time it will be
necessary to do a more thorough cleaning, using a
proprietary oven cleaner.
If the soilage has become set, after the oven has cooled
down, the following process will help to soften the
splatters to help make cleaning easier.
F
1. Place the grill/ meat pan on the oven shelf
positioned in the lowest runner.
2. Add a few drops of washing-up liquid to the
pan and fill to about 12 mm. with boiling water
from the kettle.
3. Close the oven door, turn the oven function knob
on fan oven and set the thermostat knob
on 50°C.
4. After 15 minutes, turn off the thermostat and
allow the fan oven to continue without heat for
a further 5 minutes, when the temperature of
the water will have cooled down.
5. Carefully remove the pan of water from the oven
and use normal oven cleaners to clean away
soil residues.
6. Leave a little of the soapy water to soak into
any burned on spillage on the floor of the oven
for a longer time if necessary.
Before cleaning always allow the cooling fan to
cool the oven down before switching off at the
electricity supply.
The oven should be kept clean at all times. A
build-up of fats or other foodstuffs could result in
a fire, especially in the grill pan.
Cleaning materials
Before using any cleaning materials on your oven, check
that they are suitable and that their use is recommended
by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives should
also be avoided.
External cleaning
Regularly wipe over the control panel, oven door and door
seal using a soft cloth well wrung out in warm water to
which a little washing up liquid has been added.
To prevent damaging or weakening the door
glass panels avoid the use of the following:
•Household detergent and bleaches
•Impregnated pads unsuitable for non-stick
saucepans
•Brillo/Ajax pads or steel wool pads
•Chemical oven pads or aerosols
•Rust removers
•Bath/Sink stain removers
Clean the outer and inner door glass using warm soapy
water. Should the inner door glass become heavily soiled
it is recommended that a cleaning product such as Hob
Brite, or Bar Keepers Friend is used.
DO NOT clean the oven door while the glass
panels are warm. If this precaution is not
observed the glass panel may shatter.
If the door glass panel becomes chipped or
has deep scratches, the glass will be weakened
and must be replaced to prevent the possibility
of the panel shattering. Contact your local
Service Centre who will be pleased to advise
further.
Cleaning the Oven
Replacing the Oven Light
If the oven bulb needs replacing, it must comply with the
following specifications:
- Electric power:25W,
- Electric rate: 230-240 V (50 Hz),
- Resistant to temperatures of 300°C,
- Connection type: E14.
These bulbs are available from your local Force Service
Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the new
one.
4. Refit the glass cover.
5. Restore the electrical supply.