Yamaha F25 - Manual (Page 55)

Trouble Recovery
50
7. Remove the starter case by pulling it to-
wards you.
8. Install the fuel tank bracket by installing
the bolts.
9. Install 2 bolts into the rear section of the
fuel tank.
10. Prepare the engine for starting; see page
21. Be sure the engine is in neutral and
that the engine stop switch lanyard lock
plate is attached to the engine stop
switch.
11. Turn the lever on the carburetor to oper-
ate the choke system when the engine is
cold. After the engine starts, return the le-
ver to the original position.
12. While lifting the fuel tank, insert the knot-
ted end of the emergency starter rope
into the notch in the flywheel rotor and
wind the rope several turns clockwise.
NOTE:
If the rope is too long after winding it around
the flywheel, shorten its length at the handle.
13. Pull the rope slowly until resistance is felt.
14. Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
U69M15E0.book Page 50 Wednesday, April 5, 2006 4:48 PM